GLOCK

1" Carbon Cap - Vortex Viper for Glock

$30.00

The 1" wide Caps are for the medium frame Glocks (19,17,22 etc) The 1.125" (ie. 1 1/8") wide Caps are for the larger frame Glocks (20, 30, 40 etc) which will come at a later date.  If you ever have any questions on which Cap to choose and are not...

Out of stock

BOB Cut - 34/35/17L/47/48/49

$30.00

The Bob Cut trims the front dust cover at an angle on long slides like the 34, 35, 17L, 47, 48, 49, etc.   If holster wear/durability is a concern then we highly recommend going with our Black Nitride as Cerakote is a wearable item...

Add to Cart

Enhanced Rear Serrations

$25.00

If holster wear/durability is a concern then we highly recommend going with our Black Nitride as Cerakote is a wearable item.  We deepen the rear serrations and add one more in the rear! A much sharper edge for a much better grip.  If (NONE)...

Add to Cart

Standard Rear Serrations

$25.00

If holster wear/durability is a concern then we highly recommend going with our Black Nitride as Cerakote is a wearable item.  For adding standard rear serrations to blank slides.  Cerakote and Black Nitride are for the entire slide. (Black...

Add to Cart

+0 Magazine Base Plate for Glock 43X/48

$20.00

JagerWerks +0 Magazine Extension with Spring for OEM Glock 43X/48 Single Stack Magazines.   Machined in house from 6061 Aluminum, black (Type III) Hardcoat Anodized.   If you would like your magazine extension/base plate to be...

Out of stock

Base Plate +0 for Glock

$20.00

JagerWerks +0 Base Plate for Glock Magazines.   Machined in house from 6061 Aluminum, black (Type III) Hardcoat Anodized. Uses stock magazine spring and base pad retention insert Our new base pads utilize the factory Glock retainer, to remove,...

Add to Cart

Carbon Back Plate for Glock

As low as $20.00

Carbon fiber back plate for all Glock models! (except 42)*   *NOTICE: THIS PRODUCT HAS BEEN DESIGNED, ENGINEERED, AND MANUFACTURED TO THE HIGHEST QUALITY STANDARDS AND IS SUITABLE FOR THE PURPOSE AND USE SPECIFIED. NO LIABILITY IS EXPRESSED OR...

Choose Options

MOS+ 3rd Screw Upgrade for Factory MOS

As low as $20.00

This upgrade is for a Factory MOS to be drilled and tapped for the third hole for our MOS+ plates.  Coating isn't necessary when using threadlocker. It isn't a through hole, but it's always good to coat if it is cause for concern.  This is...

Choose Options