Outfit your new (or old) Glock 17/34/45/19X with a set of magazine extensions and a base plate.
You get two +5 Magazine Extensions, magazine springs, a flathead screw driver for prying/servicing, and one +0 base plate.
Limited time promotion, only available while supplies last. Only available as G17/34/19X extensions.
JagerWerks +5 Magazine Extension with Spring for Glock 17/34/45/19X Magazines.
Machined in house from 6061 Aluminum, black (Type III) Hardcoat Anodized.
12 Coil Spring for +5 Magazine Extensions included.
Our new +5 Magazine Extensions use ramped retention posts and require no tools to secure. For removal you just need a small flathead or a prying tool to get the rear wall of the magazine over the posts while applying pressure to slide the magazine out.
The +0 Base Plate uses the stock magazine spring and base pad retention insert.
Our new base pads utilize the factory Glock retainer, to remove, depress the retainer with a punch while applying pressure to the front and sides of the magazine.
We will not ship these magazine extensions to California, New York, New Jersey, Connecticut, Massachusetts. Illinois, Rhode Island, Hawaii, or Washington.
If you would like your magazine extension to be coated to match your slide check out https://jagerwerks.com/accessory-cerakote/
DISCLAIMER: “GLOCK” is a federally registered trademark of
GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. and
GLOCK Ges.m.b.H. Neither JagerWerks Engineering LLC nor this site
are affiliated in any manner with, or otherwise endorsed by, GLOCK, Inc.
or GLOCK Ges.m.b.H. The use of “GLOCK” on this page is merely to
advertise the sale of GLOCK pistols, parts, or components. For
additional genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and
parts visit www.glock.com.